RMP Universal Buffing Pad Washer
(9007)
Whether you're using a rotary buffer, orbital polisher, dual-action polisher, corded or cordless drill, pneumatic polisher, or even a dual-head polisher, the Universal Pad Washer will work with your tool.
Use for cleaning foam pads, wool pads, felt pads, buffing bonnets, round microfiber applicators, round foam applicators, brushes, goblet buffs, and polishing balls.
Always use a Ground Fault Circuit Interrupter (GFCI) when using any corded electrical device around water.
Instructions:
Fill the bucket with water. The water level should be no more than 1/4" - 1/2" above the insert, with springs fully compressed.
Orient the Universal Pad Washer so the wing nut on the Splash Guard Assembly is on the user's right hand side.
Apply three to five sprays of PRS (Pad Renewing Solution) (included in your box) to the object you wish to clean.
Place polsiher/buffer inside Universal Pad Washer and close the Splash Guard.
Heavily soiled pads:
For pads with heavy dried compound, run polisher/buffer on the Universal Pad Washer first for about 10 seconds to deeply moisten the pad. Next, apply PRS and allow up to one minute for PRS to penetrate the pad.
For best results, START POLISHER/BUFFER ON LOWEST SPEED SETTING, and clean for 20 to 40 seconds. While cleaning, move polisher/buffer around inside Universal Pad Washer as required to clean all areas of the pad.
Speed setting on tool may be increased as necessary, however, limit your polisher/buffer to no more than 25% of its maximum speed setting while cleaning on the insert or extension.
Drying Instructions:
Standard Drying:
After cleaning, keep Splash Guard lid closed, raise polisher slightly off Grit Guard and spin out excess moisture at a higher speed.
Advanced Drying:
Place the extension in the Splash Guard Lid, over the area printed "DRY PAD HERE". Operate polisher/buffer on higher speed setting against extension.
Product Reviews :
Write a review
Miscellaneous :
Email a Friend
Product Inquiry
|
Related Products :
Category : N/A
|
